Process For Installing Asphalt Paving

Asphalt paving installation can be a very labor-intensive job. It can also be complicated if no specific steps are followed along with the preparatory phase not completed properly. If the area is not fully prepared and you are trying to lay the asphalt, it will not be durable and smooth.

Most homeowners will hire a professional paving asphalt company with many years of experience to do this work and have the references to prove it. You can hire an expert for paving in Charlotte via https://www.joemcasphaltservices.com/.

Sealcoating and Striping

Marking area

If you run into a road is poured, the starting point could be next to a garage or at the end of what would be your way. After you select the point you start to mark it with a piece of wood on the ground. Continue to mark the area with a tape measure around the outside of the area.

Preparation process

Dig the area to get ready for gravel and asphalt. Taking the string of a wooden pole ahead and dig out the string area for at least twenty inches. You want to get it as close as possible less than twenty inches.

Building a strong foundation

You will need some cheap lumber to build a barrier around the perimeter, making sure that it is flush with the ground. You can use small bets around the outer edge for securing the frame if you need too. After you have compacted the underground, you can begin the next step.

Leave a Reply

Your email address will not be published. Required fields are marked *